| 1. |
The building modeled in figure1 is a _____________office building with a total floor area of 2250 m2 (24,200 ft2). |
|
|
Two storeyed |
|
|
Four storeyed |
|
|
Single storeyed |
| 2. |
Table 1 represents the __________________ thermal properties for the office building. |
|
|
Wall, roof, slab and window |
|
|
Floor |
| 3. |
Is there a difference between the fractional occupancy schedule in figure2 and the fractional lighting schedule in figure 3? |
|
|
Yes |
|
|
No |
| 4. |
The retail building in the study is a ______________ building with a total floor area of 1125 m2 (12,100 ft2). |
|
|
One storeyed |
|
|
Two storeyed |
|
|
Four storeyed |
| 5. |
Figure 5 on page12 represents the _________________________. |
|
|
Floor plan of the retail building |
|
|
Wall, roof, slab and window of the retail building |
| 6. |
Do the fractional lighting schedule in figure7 and the fractional receptacle load schedule in figure 8 have any similarities? |
|
|
Yes |
|
|
No |
| 7. |
The wall, roof, slab and window thermal properties used for modeling the apartment building in table3 are for a _________residential building. |
|
|
One storeyed |
|
|
Two storeyed |
|
|
Four storeyed |
| 8. |
The office building system included __________________________ and a ______________ serving the common loop. |
|
|
Water-source heat pumps (WSHPs) with a cooling tower, boiler |
|
|
None of the above |
| 9. |
The retail building system has a packaged rooftop unit which includes a______________ and ___________with a separate system for each individual zone. |
|
|
DX cooling coil, a gas furnace |
|
|
None of the above |
| 10. |
Figure 14 represents __________________. |
|
|
Dependence of scalar ratio on target air leakage rate |
|
|
Dependence of scalar ratio on baseline air leakage rate |
|
